Replacement Part List

11
Basic Cutting Procedure
This unit is designed for trimming small branches and limbs up
to recommended 6.5 in. (16.5 cm), not to exceed a max cut of
7.5 in. (19 cm) in diameter depending on the wood type.
Practice cutting a few small limbs using the following
technique to get the “feel” of using the saw before you begin a
major sawing operation.
• Take the proper stance in front of the tree with the
saw OFF (Fig. 19).
• Squeeze the trigger and let the chain accelerate to full
speed before entering the cut.
• Keep the saw running the entire time you are cutting;
maintain a steady speed.
• Allow the chain to cut for you; exert only light downward
pressure. If you force the cut, damage to the bar, chain, or
unit can result.
• PUSH and PULL – This reaction force is always opposite
to the direction the chain is moving when it is in contact
with the wood. Thus, the operator must be ready to
control the PULL when cutting on the bottom edge of the
bar, and PUSH when cutting along the top edge.
• Do not put pressure on the saw at the end of the cut.
Pruning
Pruning is the process of trimming limbs from a live tree.
• Remove long branches in several stages.
• Cut lower branches rst to allow the top branches more
room to fall.
• When pruning trees, it is important not to make the
nishing cut next to the main limb or trunk until you have
cut o the farthest lying limb. This will reduce the weight
and prevent stripping the bark from the main member.
• Under cut the branch 1/3 through for your rst cut.
Your second cut should over cut to drop the branch o
(Fig. 20). Be prepared to balance the weight of the pole
chain saw when the limb falls.
NOTE: For the second and nal cuts (from above the limb
or branch), hold the front cutting guide against the limb
you are cutting (Fig. 21). This will help steady the limb
and make it easier to cut. Allow the chain to cut for you;
exert only light downward pressure. If you force the cut,
damage to the bar, chain, or motor can result.
• Make your nishing cut from the topside of the branch
smoothly and neatly against the main member so the bark
will grow back to seal the wound.
• Release the trigger ON/OFF switch as soon as the cut is
completed. Failure to follow proper cutting procedures will
result in the bar and chain binding and becoming pinched
or trapped in the limb.
Limbing
Limbing is the process of removing branches from a fallen tree.
• You should cut limbs one at a time. Remove the cut limbs
from the work area often to help keep the work area clean
and safe.
Fig. 19
60º MAXIMUM
Fig. 20
Load
Second cut
First cut
1/3 diameter
Finishing cut
Fig. 21
Cutting guide