Replacement Part List

10
5. To turn the tool OFF, release the trigger switch (Fig. 14).
NOTE: Do not press the trigger switch until you are ready
to make a cut.
Adjusting the Telescoping Pole
1. Disconnect the saw from the power supply and wait until
the saw completely stops.
2. Unclip the cam-lock to release the pole (Fig. 15).
3. Extend the pole to the desired length (Fig. 16).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
4. Lock the pole in position by closing the cam-lock (Fig. 17),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
mWARNING! Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.
Tightening the Bolt
The retaining bolt may need tightening to secure the telescopic
pole in place.
1. Unclip the cam-lock. Using the hex key wrench, tighten
the cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a dierent
height (Fig. 18).
Cutting Tips
Proper Cutting Stance
• Balance your weight with both feet on solid ground.
• Your body should always be to the left of the chain line.
• The most typical cutting application is to position the
unit at an angle of 60° or less depending on the specic
situation (Fig. 19). As the angle of the pole chain saw shaft
to the ground increases, the diculty of making the rst
cut (from the underside of the limb) increases.
Fig. 14
Safety lock button
On/O
switch
Cord
restraint
Fig. 15
Cam-lock
Fig. 16
Pull
Pull
Fig. 17
Cam-lock
Fig. 18
Hex key wrench
Cam-lock nut