Use and Care Manual

8
4. Three extension tubes are equipped with the unit. If
needed, insert the rst extension tube into the vacuum
hose end, and press rmly to lock. Follow the same
instruction to assemble the second and third extension
tubes (Fig. 4).
5. Select desired attachment, connect it with the end of the
extension tube, press rmly to lock securely. Your wet/dry
vacuum is ready for use (Fig. 5).
Operation
mWARNING! This equipment incorporates parts such
as switches, motors or the like that tend to produce arcs or
sparks that can cause an explosion. Do not pick up ammable,
combustible, or hot materials. Do not use around explosive
liquids or vapors, as electrical devices produce arcs or sparks
which can cause a re or explosion – do not use at lling
stations or anywhere gasoline is stored or dispensed.
Starting + Stopping
Do not switch on the wet/dry vacuum until it has been
completely assembled. Before switching on the unit, always
check the power cord for signs of damage. Use only intact
cords.
mWARNING! Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
mWARNING! Before switching on the wet/dry vacuum,
make sure that it is not in contact with any foreign objects.
1. Make sure the lters are installed before starting.
2. Make sure the power head and the vacuum hose are
installed properly and locked securely.
3. Install the desired brush attachment onto the end of the
hose. Use the extension tubes if needed.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specied on the rating plate.
Plug the power cord into the outlet (Fig. 6). If an extension
cord is used, make a knot with the two cords as shown in
Table 1.
5. To start the unit, press the ON/OFF switch on the ON(I)
position (Fig. 7), as indicated.
6. To stop the unit, press down (O) on the ON/OFF switch, as
indicated (Fig, 7).
Operating Tips
This electric wet/dry vacuum is designed to clean hard
surfaces. It is only suitable for vacuuming wet or dry, light
materials. The vacuuming of heavy materials such as metal,
stones, branches, broken glass is expressly excluded.
mWARNING! Use the wet/dry vacuum only in daylight or
good articial light.
• Make sure the power head is properly installed and
secured when using. Make sure each lock is secured.
Failure to properly secure the locks could cause the power
head to release from the tank.
Fig. 4
Vacuum hose
Extension tube
Extension tubes
Fig. 5
Selected accessory
Extension tube end
Fig. 6
Power cord
Fig. 7
ON (I)OFF (O)
ON/OFF switch