How to Guide
9
9.  Connect the garden hose adapter (female coupler) to 
the water inlet of the pressure washer, then thread your 
garden hose (male end) into the garden hose adapter 
(Fig. 9). The garden hose must have an internal diameter 
of at least 13 mm (1/2 in.) and must be reinforced. The 
water supply must be at least equal to the washer delivery 
capacity.
  NOTE: The machine is not suitable for connection to the 
potable water main.
10. Attach garden hose to water supply (Fig. 10).
mWARNING! Do not connect to potable water system.
mWARNING! If connection is made to a potable water 
system, the system shall be protected against backow.
mWARNING! The intake water temperature must not 
exceed 104ºF/40ºC. The water supply must not exceed 
0.7 MPa.
mCAUTION! The washer must only be used with clean 
water; use of unltered water containing corrosive chemicals 
will damage the washer.
Operation
Using the Pressure Washer
mIMPORTANT! This pressure washer is equipped with 
a micro-switch sensitive to water ow. This Total Stop System 
(TSS) senses water ow in the pump. When the trigger is 
released, water stops owing through the pump. The TSS then 
automatically turns the motor o to protect the pump from 
overheating, thus saving energy and prolonging pump life.
1.  Position the washer as CLOSE as possible to the water 
supply. 
2.  The washer must be used on a secure and stable surface 
in a standing, upright position (Fig. 11). 
3.  Make sure the unit is switched o before plugging the unit 
into the power outlet. 
4.  Check that the electrical supply voltage and frequency 
(Volt/Hz) correspond to those specied on the rating plate. 
If the power supply is correct, you may now plug the 
pressure washer into the power outlet (Fig. 12).
  NOTE: The GFCI may need to be reset when rst plugged 
into the electric outlet. Press the "Reset" button until 
the power light indicator on the GFCI illuminates when 
plugged in.
5.  Turn the water supply tap on completely.
R
Fig. 9
Garden hose
This end to 
water inlet
Garden hose  
(male end)
Fig. 10
Connect to water supply
Garden hose
Fig. 11
RESET
TEST
Fig. 12
GFCI
Power light 
indicator
Reset
Water inlet










