User Manual

10
12. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specied on the pressure
washer rating plate. If the power supply is correct,
you may now plug the pressure washer into the power
outlet (Fig. 13).
NOTE: The GFCI may need to be reset when rst plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
mCAUTION! To prevent damage to the appliance, do not
allow it to operate dry. Before starting the appliance, make
sure that it has proper and stable supply of water.
Operation
mIMPORTANT! This pressure washer is equipped with
a micro-switch sensitive to water ow. This Total Stop System
(TSS) senses water ow in the pump. When the trigger is
released, water stops owing through the pump. The TSS then
automatically turns the motor o to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 14).
3. Turn the water supply tap on completely.
4. Unlock the safety lock, then press the trigger for a few
seconds until the water ow is steady. Operating the
pressure washer in this manner will allow air to escape
and discharge residual pressure in the hose (Fig. 15).
5. Keeping the trigger pressed, turn the switch to the ON (I)
position to start the pressure washer.
6. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is depressed
and shuts o when the trigger is released.
Connecting Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a dierent spray pattern
(Fig. 16):
• Turbo nozzle: Creates a powerful jet of oscillating water
and cleans faster than standard nozzles, perfect for
cleaning brick, concrete and vinyl.
• Jet nozzle: Nozzle can be adjusted from 0º to 45º.
Great for washing windows, patio furniture, fences, cars,
grills and more.
• 90º nozzle: Angled nozzle perfect to cleaning hard to reach
areas, such as under the car or roof of SUV, house roof,
gutters and air conditioning + condenser units.
RESET
TEST
Fig. 13
GFCI
Power light
indicator
Reset
Fig. 14
Fig. 15
Trigger
Safety lock
Fig. 16
Turbo nozzle 90º nozzleJet nozzle