Replacement Part List

Maintenance

General

• After each use, dump and clean the hopper.

• Rinse/dry inside and outside of the sweeper after

each use.

• Periodically check all nuts, bolts, and screws for

proper tightness.

• Annually clean out and lightly lubricate parts.

• Use a glossy enamel spray paint to touch up scratched or

worn painted metal surface.

• Never exceed the hopper load capacity rating of

52.3 gal (198 l) It will damage the hopper bag.

Lubrication

The bearings in the sweeper have been pre-lubricated at the

factory. However it’s recommended that a few drops of light oil

should be added to the brush shaft bearings twice a year. Also,

the gear should be cleaned every two years. After cleaning

apply an even coat of light grease.

1. Use a screw driver to pop o the hub cap (Fig. 13).

2. To remove the wheel, take out the circlip and the at

washer; you will see the gear and the shaft (Fig. 14).

3. Remove the circlip on the gear, the gear can be taken o

easily (Fig. 15).

4. Clean the gear and lubricate the shaft as needed, then

reassemble the wheel in a reverse sequence.

Fig. 13

Hub cap

Fig. 14

Circlip

Flat washer

Wheel

Gear

Shaft

Fig. 15

Circlip

Gear