Replacement Part List

Assembly
Your push lawn sweeper requires assembly. Account for all
parts and hardware before beginning assemble. If any parts
are missing or damaged, or if you have any questions or need
additional instructions, please call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Tools needed:
• Pliers
• 10 mm wrench
1. Attach the supporting leg to the sweeper assembly and
secure with a M6 x 30 hex bolt, lock washer, and M6 lock
nut (Fig. 1). Do not tighten yet. Repeat for the other side.
2. Assemble the handle frame over the supporting legs. Align
the holes in the handle frame and supporting legs (Fig. 2).
3. Secure the supporting legs and the handle frame with two
M6 x 30 carriage bolts, bag rod clips, lock washers, and
handle knobs (Fig. 3).
4. Fully tighten all hardware in step 1.
5. Put two bag rod clips on the inside of each supporting leg,
secure by a M6 x 30 carriage bolt, a lock washer, and a
handle knob (Fig. 4).
Fig. 1
Sweeper
assembly
Support leg
M6 x 30
hex bolt
M6 lock nut
Lock washer
Fig. 2
Handle frame
Supporting
leg
Fig. 3
Handle
frame
Supporting
leg
Handle
knob
Lock washer
Bag rod
clip
M6 x 30
carriage
bolt
Fig. 4
Handle knob
Lock washer
Bag rod clip
M6 x 30
carriage bolt
4