Use and Care Manual

3
Switch the product o, disconnect it from the power supply
and take the following steps:
– inspect for damage;
– check for, and tighten, any loose parts;
– have any damaged parts replaced or repaired with parts
having equivalent specications.
Operation
1. Use the product only in daylight or good articial light.
2. Never operate the product with damaged guards or
shields or without guards or shields in place.
3. Keep hands and feet away from the cutting device at all
times and especially when switching on the motor.
4. Before using the product and after any impact, check for
signs of wear or damage and repair as necessary.
5. Always disconnect the product from the power supply
(i.e., remove the plug from the power supply)
– whenever leaving the product unattended;
– adjusting the working position of the cutting device;
– before clearing a blockage;
– before checking, cleaning or working on the product;
– after striking a foreign object;
– whenever the product starts vibrating abnormally.
6. Ensure that the pole hedge trimmer is correctly located in
a designated working position before starting the motor.
7. While operating the pole hedge trimmer, always ensure
that the operating position is safe and secure, especially
when using steps or a ladder.
8. Do not operate the pole hedge trimmer with a damaged or
excessively worn cutting device.
9. Always ensure that all handles and guards are tted when
using the pole hedge trimmer. Never attempt to use an
incomplete pole hedge trimmer or one tted with an
unauthorized modication.
10. Always use two hands to operate a pole hedge trimmer
tted with two handles.
11. Always be aware of your surroundings and stays alert for
possible hazards of which you may not be aware due to
the noise of the product.
12. Take care against injury to feet and hands from the cutting
device.
13. Always ensure that the air vents are kept clear of debris.
14. Wear slip-resistant foot protection and protective clothing
when using this product.
15. Always keep proper footing and operate the product
only when standing on a xed, secure and level surface.
Change working positions regularly to avoid tiredness and
ensure a comfortable working position at all times.
16. Never use replacement parts or accessories not provided
or recommended by the manufacturer.
17. The use of this product may be restricted by regional or
local regulations.
Vibration + Noise Reduction
To reduce the impact of noise and vibration emission, limit the
time of operation, use low-vibration and low-noise operating
modes as well as wear personal protective equipment.
Take the following points into account to minimise the vibration
and noise exposure risks.
1. Only use the product as intended by its design and these
instructions.
2. Ensure that the product is in good condition and well
maintained.
3. Use correct attachments for the product and ensure they
are in good condition.
4. Keep tight grip on the handles/grip surface.
5. Maintain this product in accordance with these
instructions and keep it well lubricated (where
appropriate).
6. Plan your work schedule to spread any high vibration tool
use across a longer period of time.
Emergency
Familiarize yourself with the use of this product by means of
this instruction manual. Memorize the safety directions and
follow them to the letter. This will help to prevent risks and
hazards.
1. Always be alert when using this product, so that you can
recognize and handle risks early. Fast intervention can
prevent serious injury and damage to property.
2. Switch o and disconnect from the power supply if there
are malfunctions. Have the product checked by a qualied
professional and repaired, if necessary, before you
operate it again.
Residual Risks
Even if you are operating this product in accordance with all
the safety requirements, potential risks of injury and damage
remain. The following dangers can arise in connection with the
structure and design of this product:
1. Health defects resulting from vibration emission if the
product is being used over long periods of time or not
adequately handled and properly maintained.
2. Injuries and damage to property due to broken cutting
attachments or the sudden impact of hidden objects
during use.
3. Danger of injury and property damage caused by ying
objects.