Replacement Part List

8
Operation
Loading + Unloading Screwdriver Bits
1. Position the forward + reverse selector switch to the
center “LOCK” position (Fig. 2).
2. Press and slide the loading bolts on both sides to the
back then release the loading bolts to lock into place
(Fig. 3).
3. By rotating the bit cylinder in the chamber, select the
driving bit best suited for the job and place it to the top.
You can view the selected bit through the bit port (Fig. 6).
NOTE: For the cylinder to rotate, slide the loading bolts to
the back and lock into place.
4. Press and slide the loading bolts on both sides forward to
load the selected bit into the collet (Fig. 7).
NOTE: The loading bolts will not advance if the cylinder is
not properly seated in the top position.
5. Sliding the loading bolts back will draw the bit back into
the bit cylinder.
Selecting the Direction of Rotation
mWARNING! Be sure the trigger switch is released when
changing the position of the forward + reverse selector switch.
Always store the tool in the locked/o position.
NOTE: Always check the direction of the cordless screwdriver
rotation before use.
1. To select forward rotation, press the forward selector
switch from right to left at against the cordless
screwdriver (Fig. 8).
2. To select reverse rotation, press the reverse selector
switch in the opposite direction (Fig. 9).
3. The center position locks the tool (Fig. 10).
R
Fig. 6
Bit cylinder
Bit port
R
Fig. 7
Loading bolts
Bit
Collet
R
Fig. 8
Forward rotation
switch
R
Fig. 9
Reverse
rotation switch
Fig. 10
To lock
the tool
To lock
the tool