Installation Guide

Unpacking
Carton Contents
•
Soil meter
• Manual and registration card
Operation
1. Set your desired soil testing mode on the
mode selector. The three modes are:
Moisture, Light and soil pH (Fig. 1).
2. Insert the probe tips into the soil you wish
to measure (Fig. 2).
m
CAUTION! Do not force the probes into
hard soil or at hard objects, as this can easily
damage the probes.
3. Take your measurements according to the
white indicator on the gauge (Fig. 3).
NOTE: Do not cover the light sensor.
NOTE: Water may not penetrate the soil evenly,
try measuring at different locations and depths
to get an accurate reading.
NOTE: Water before testing. If the soil is too dry
the indicator will not move.
4. Remove the probes from the soil and wipe
them clean after each use.
m
CAUTION! Do not leave your soil meter
in the soil for too long.
Service + Support
If your Sun Joe
®
SJ-MMPH1 3-in-1 Soil Meter
requires service or maintenance, please call
Snow Joe
®
+ Sun Joe
®
customer service
at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Model + Serial Numbers
When contacting the company or arranging
service from an authorized dealer, you will need
to provide the model and serial numbers, which
can be found on the registration card. Copy
these numbers into the space provided below.
Fig. 1
Fig. 2
Probe tips
Fig. 3
Record the following numbers from the registration card
of your new product:
Model #:
Serial #:
S J - M M
P H 1
3