Replacement Part List

9
2. Allow the machine sufficient time to shred the load
completely before inserting the next handful.
NOTE: Do not overload the machine as to avoid clogging
the funnel and getting the motor stuck.
mWARNING! Wear protective gloves while loading the
machine. Keep your hands away from the chuck and the
cutting lines when loading the machine.
mWARNING! Overloading the mulcher + shredder may
result in permanent damage to the motor. Always wear safety
glasses, hearing protection and a dust mask.
Adjusting the Mulch Adjustment Dial
The mulch adjustment dial regulates the particle size and
speed at which material passes through the unit. When the
control dial is set in the COARSE position, material will be
processed faster, but will yield a larger particle size than if the
dial were set to FINE. The FINE position setting will discharge
the material slower, but will yield the smallest particle reduction
ratio (up to 17 : 1). Use the special settings for pine needles,
grass clippings, and thatch as needed. For best results,
material should be shredded when dry (Fig. 13).
Fig. 12
Fig. 13
Mulch adjustment dial
Overheating Protection
Your electric leaf mulcher + shredder is designed with
overheating protection. If the shredder is clogged during
shredding, the overheating protection will cut the power
automatically to protect your shredder. Wait at least 1 minute
before restarting the unit when the power is cut.
To restart the leaf mulcher + shredder, rst ip the On/O
switch down, before ipping it up to turn it on again.
Maintenance
mATTENTION! Before performing any cleaning or
maintenance, turn off the unit and disconnect it from the power
supply. Wait until the unit stops completely.
Cleaning
1. Use a warm damp cloth and a soft brush to clean the
funnel cover and the funnel.
2. Never spray water on the mulcher + shredder motor or
wash it with water. Do not use detergents or solvents as
these could cause irreparable damage to your mulcher +
shredder.
3. Make sure the ventilation slots are always kept clean and
are free of debris.
4. Unlock the two latches and remove the funnel to clean the
inside of the unit.
5. Clear the chuck and the discharge area of any clumps or
debis using the clean-out tool. Remove any wood and that
may clog the cutting lines. Check the lines for damage.
Cutting Lines Replacement
The mulcher + shredder has two 0.1 in. x 12.6 in. (2.5 mm x
320 mm) heavy-duty trimmer lines that are attached to the
spinning head. Before any maintenance or cleaning is done on
the trimmer lines, always turn the switch o and disconnect
the plug from the outlet, and wait until it comes to a complete
stop.
IMPORTANT: Only use original replacement parts specied for
this leaf mulcher + shredder.
You can purchase replacement cutting lines (Model SDJ616L)
and other genuine replacement parts by ordering online at
sunjoe.com or, to order by phone, contact Snow Joe
®
+ Sun
Joe
®
customer service at 1-866-SNOWJOE (1-866-766-9563).
The use of parts that do not meet the original equipment
specications may lead to subpar performance of the mulcher
+ shredder, may compromise operator safety, and will void the
manufacturer’s warranty.
1. Replace the cutting line when a noticeable decrease in
shredding efficiency is observed. To remove the worn
cutting lines, remove the funnel cover, cut the old lines
and pull the remaining line out of the chuck.