User Guide

2
accessories. Inspect the trimmer + edger periodically and
replace if damaged. Repair the trimmer + edger only at an
authorized service facility. Keep handles dry, clean, and
free from oil and grease.
14. Checked for damaged parts – Before continuing to use
the trimmer + edger, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function. Check
for the alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition that
may aect the trimmer + edger’s operation. A guard or
other part that is damaged should be properly repaired or
replaced by an authorized service center unless indicated
elsewhere in this manual.
C) ADDITIONAL SAFETY INSTRUCTIONS FOR GRASS
TRIMMER + EDGER
1. Keep guards in place and in working order.
2. Keep hands and feet away from the cutting area.
mWARNING! Never use steel blades or other devices.
Use of any other accessories or attachments will increase the
risk of injury.
mCAUTION!
The safety guard is critical to the safety of the operator and the
safety of people standing within a safe distance of the trimmer
+ edger. The safety guard keeps the trimmer + edger in good
working order and must always be in place during operation.
• Do not try to stop the cutting device (SharperBlade
™
) with
your hands. Always let it come to a stop by itself.
mWARNING! After switching o the tool, the cutting
device (SharperBlade
™
) continues to rotate for a few
seconds.
• Only use the original type of SharperBlade
™
. Do not under
any circumstances use metal line or nylon line instead of
SharperBlade
™
.
• Do not use the tool to cut grass which is not on the ground.
For example, do not cut grass growing on walls or rocks.
• Do not switch on the tool in an enclosed or poorly ventilated
space or in the presence of ammable and/or explosive
substances such as liquids, gases and powders.
• Only cut during broad daylight or with adequate articial
light.
• Check that all grass cuttings and dirt have been removed
from the ventilation vents.
• Do not cross roads or gravel paths while the tool is still
running.
• When the tool is not in use, store it in a dry place and out of
reach of children.
• After use, disconnect the tool from the power supply and
check for damage. If you have the slightest doubt about the
condition of the tool, contact an authorized service center.
• Only use the tool according to the instructions given in this
manual.
• Check regularly that the screws are tight.
• Do not try to repair the tool or access internal parts. Contact
an authorized service center.