Replacement Part List

10
Mowing Tips
mWARNING! Inspect the area prior to mowing and
remove all the stones, sticks, wires and other debris that might
be picked up and thrown by the rotating blade.
mWARNING! If you strike a foreign object, immediately
stop the motor and disconnect the power cord. Thoroughly
inspect the mower for any damage. Repair the damage before
resuming operation.
1. The directional method of operation is recommended to
obtain the maximum cutting performance and to reduce
the risk of the electrical extension cord entering the
cutting path (Fig. 12).
2. Follow these instructions to mow the cutting area:
A. Proceed to cut as shown in Fig. 12, working from
position 1 towards position 2.
B. At position 2, turn right and proceed to position 3.
C. Continue to the end of the cutting area, turn left and
proceed to position 4.
D. Proceed as shown in Fig. 12, always working away
from the electric extension cord.
IMPORTANT: The mower blade will continue to rotate as
long as the switch lever is pulled. Do not reach inside the
blade housing or attempt to lift the mower until the blade
has completely stopped and the electrical supply to the
mower has been disconnected.
3. Be sure to check the blade periodically for signs of wear
and sharpen it at least once per year, as described in the
maintenance section.
NOTE: A sharp blade will greatly enhance the
performance of the mower, especially when cutting tall
blades of grass.
Adjusting the Cutting Height
Follow these instructions to adjust the cutting height of the
lawn mower.
mWARNING! Before making these adjustments,
disconnect the power supply to the mower and wait until the
rotating blade has come to a complete standstill. Wearing
gloves is recommended due to the close proximity of the
cutting blade.
ALWAYS FOLLOW ALL SAFETY PRECATIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power o and unplug the lawn mower.
2. Remove and empty the grass bag.
3. Place the lawn mower on its side.
4. The wheel axles can be placed into 3 dierent cutting
heights: low (will cut grass the shortest), medium, and high.
3-Position Height Adjustment:
1. Low: 1.18 in. (30 mm)
2. Medium: 1.93 in. (49 mm)
3. High: 2.52 in. (64 mm)
The cutting height tolerance is +/- 0.2 in. (5 mm).
Fig. 12
4
1
3
2
Fig. 13
High setting
Medium setting
Low setting
Rod axle