Replacement Part List

2. Pull the push lock button on the battery to pull the battery

pack up and out of the equipment (Fig. 9).

3. Check that the mains voltage is the same as that marked

on the rating plate of the battery charger. Then, insert the

charger's plug into the electrical wall outlet. When you

plug in the charger, the top green light will illuminate and

stay green (Fig. 10).

4. Place the battery pack into the charger by sliding the

pack as shown to lock it into position. When you insert

the battery into the charger, the bottom red light will

illuminate to indicate that the battery is charging (Fig. 11).

5. When the bottom light turns green, the battery is fully

charged (Fig. 11).

NOTE: An alternately ashing red and green light indicates a

temperature abnormality (i.e. that the battery pack is either

too hot or too cold). If there is only a red blinking light, this

indicates that something is wrong with the battery. Contact

Snow Joe

+ Sun Joe

customer service at 1-866-SNOWJOE

(1-866-766-9563).

Fig. 8

Locking

button

Battery

cover

Fig. 9

Push lock button

Fig. 10

green

Power on

Fig. 11

green

Fully charged

green

red

Charging