User Manual

13
7. Remove the old auger from the housing (Fig. 18).
8. Install the replacement auger by following the above steps
in reverse order (Fig. 19).
Replacing the Belt
mWARNING! Make sure to turn o the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Disassemble the left side cover by removing the ve (5)
screws that hold it in place (Fig. 12).
2. Remove the old belt from the body by slowly turning the
auger while lifting the belt (Fig. 20).
3. Replace the worn belt with a new belt (Fig. 21).
4. Place the left side cover back into position and refasten
the ve (5) screws.
Replacing the Scraper Blade
mWARNING! Make sure to turn o the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper blade to the base
of the unit (Fig. 22).
2. Remove the old scraper blade (Fig. 23).
Fig. 18
Auger
Fig. 19
Fig. 20
Belt
Auger
Fig. 21
Belt
Fig. 22
4 screws
Drill
Fig. 23
Scraper blade