Replacement Part List

8
Fitting the Auxiliary Handle
1. Put your trimmer on a at surface and make sure that the
cable inside the poles will not be pinched when closing
the joints. Carefully unfold the upper pole and the lower
pole until the two holes in the joint are accurately aligned
(Fig. 3).
2. Insert the pole knob into the holes and tighten it to lock
the poles in place (Fig. 4).
3. The auxiliary handle comes preassembled with all
related hardware required to secure the handle clamp. To
assemble the auxiliary handle, rst loosen and remove the
handle latch, washer and bolt (Fig. 5).
3. Clamp the auxiliary handle under the soft grip on the
upper pole, align the holes on the handle clamp (Fig. 6).
4. Insert the handle bolt into the hole on the handle clamp
as shown, on the other side place the washer, and the
handle latch (Fig. 7). Fix the auxiliary handle by twisting
the handle latch clockwise, until nearly tight.
5. Fold down the latch to secure the assemble (Fig. 8).
NOTE: Adjust the position of the auxiliary handle between
the joint and the soft grip by ipping up the handle latch
and moving the handle along the pole. The auxiliary
handle should be adjusted so that your front arm will
be straight when using the trimmer. After adjusting, fold
down the handle latch to lock the auxiliary handle in
place. If the latch is dicult to fold down, loosen it 1-2
rotations before trying again.
Fig. 3
Align the holes
Upper pole
Lower pole
Cable
Fig. 4
Pole knob
Fig. 5
Auxiliary handle
Bolt
Washer
Handle latch
Auxiliary
handle
Soft grip
Handle clamp
Upper pole
Fig. 6
Align the holes
Handle bolt
Fig. 7
Handle latch
Washer
Fig. 8
Handle latch
Fold down to lock