Replacement Part List

NOTE: 250 ft. (76.2 m) replacement trimmer line

(model iON100V-STRS-250) is available for use with the

iON100V-16ST-CT cordless string trimmer. Visit snowjoe.

com to purchase this accessory online. Always use the

recommended nylon cutting line with diameter no more than

0.095 in. (2.4mm). Using line other than that specied may

cause the string trimmer to overheat or become damaged.

1. Press together both release tabs on the line spool cover

and remove the cover by pulling it straight o (Fig. 24).

2. Lift and remove the spool out of the hub (Fig. 25) and

clean out the remaining cutting line, remove any jams, or

dirt and grass residue.

3. After cleaning the jam and remaining trimmer line,

reassemble the spool and the spool cover on the motor

head. Make sure to align the marks on the spool, and the

spool cover with the metallic eyelets on the motor head

where trimmer line comes out (Fig. 26).

4. Cut one length of trimmer line 13.2 ft. (4 m) long. Insert the

line into the eyelet and push the line until the end of the

line comes out of the opposite eyelet (Fig. 27). Pull the line

from the other side until equal lengths of the line appear

on both sides of the trimmer head.

5. Use your left hand to hold the spool cover assembly

steady so it won't move, meanwhile use your right hand to

press down and rmly twist the top of the spool clockwise

as shown. The line will be wound into the trimmer head

(Fig. 28).

Fig. 24

Spool releasing tab

(on both sides)

Press

Fig. 25

Spool cover

Spool

Spring

Fig. 26

Align the marks

with the eyelet

(on both sides)

Fig. 27

Cutting line

Eyelet

Fig. 28

Spool cover

assembly

Turn the spool top