Replacement Part List

2. Gently remove the blade by lifting the end tip of the blade

o of the grass shear + hedge trimmer unit (Fig. 4).

3. Insert the desired blade into the base of the motor housing

(Fig. 5).

NOTE: You may need to manually move the blade or gear

shaft in order to align the gear shaft with the gear in the center

of the unit.

4. Align the gear shaft in the middle of the blade with the

gear in the middle of the unit. Align four lugs so that the

blade lays at against the housing for a secure t (Fig. 6).

5. Once the blade is in position, replace the blade cover by

aligning the cover with the slots on the base of the motor

housing and push forward on the blade cover until it slides

and clicks into place (Fig. 7).

NOTE: If you have any questions, please call the Snow Joe

+ Sun Joe

customer service department at 1-866-SNOWJOE

(1-866-766-9563) for assistance.

Telescoping Pole Assembly (Optional)

1. Unlock the telescoping lock by ipping it up (open), and

insert the lower pole into the upper pole. Make sure the

groove in the end of the lower pole is facing the opposite

direction of the telescoping lock. Keep the power cord

inside of the pole tubes (Figs. 8 – 9).

Fig. 4

Fig. 5

Fig. 6

Lugs

Gear shaft

Lugs

Fig. 7

Groove

Fig. 8

Lower pole

Upper pole

Telescoping lock

Lower pole

Fig. 9

Power cord

Upper pole

Telescoping lock