Operating Guide

8
Stand Assembly Fitting
1. Turn the shredder main body upside down, and x the
standing assembly with wheels on the bottom of the main
body with the 4 nuts. Tighten the nuts with the wrench
(Fig. 5).
2. Turn the shredder to let it stand on the wheels. It's now
ready for use.
Operation
Starting + Stopping
mWARNING! Before starting, ensure that the feeding
funnel is empty.
1. Secure the extension cord using the extension cord
restraint hook located at the appliance cord. Securing the
extension cord in this manner protects against accidental
disconnect of the electrical cord during operation (Fig. 6).
2. To start the chipper, press the forward end of the forward/
reverse switch, and press the ON button (Fig. 7).
3. To power the wood chipper + shredder o, reset the
forward/reverse button to the middle position, and press
the OFF button (Fig. 7).
Basic Shredding Procedure
mWARNING! Always wear ear and eye protection and
wear gloves during operation.
1. This unit is equipped with 2 hooks on each side. Hang the
handles of the provided collection bag on the two hooks
before starting (Fig. 8).
2. Connect the wood chipper + shredder to a proper power
source and switch on the unit; the wood chipper +
shredder will start to work. Insert the shredding material
inside the hopper through the feeding funnel to shred
them (Fig. 9).
Fig. 5
Main body
Standing
assembly with
wheels
Secure the nuts
Fig. 6
Extension
cord
Appliance cord
Extension cord
restraint hook
Fig. 7
Forward position
Reverse position
Forward/reverse
button
ON button
OFF button
R
Fig. 8
Collection bag
Collection
bag hook