Use and Care Manual

7
Unpacking
Carton Contents
• Electric Buer + Polisher
• Terrycloth Bung Bonnet
• Fleece Polishing Bonnet
• Manuals + Registration card
1. Carefully remove the electric Buer + Polisher and check
to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you nd damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the Buer + Polisher.
The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suocation
risk!
mWARNING! To avoid serious personal injury, read and
understand all safety instructions provided.
mWARNING! Before performing any maintenance,
make sure the tool is unplugged from the power supply.
Failure to heed this warning could result in serious
personal injury.
mWARNING! To prevent personal injury, make sure the
unit is OFF before attaching or removing any attachments.
Assembly
This unit comes fully assembled and only requires a bonnet.
mWARNING! Do not use this unit without either the
bung or the polishing bonnet. Failure to do so may result in
damaging the polishing pad.
Operation
Starting + Stopping
mWARNING! Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
1. Make sure the work surface is thoroughly clean and clear
of dust, dirt, oil, and grease.
2. Check that the power is o and unplug the polisher from
its outlet.
3.
Slip the clean Terrycloth Bung Bonnet over the polishing
pad (Fig. 1).
4. Apply about two tablespoons of wax (not included) onto
the bonnet (Fig. 2).
NOTE: Do not apply wax directly to onto the surface to be
waxed. Be careful not to use too much wax. The amount
of wax will vary depending on the size of the waxing
surface.
mWARNING! To prevent electric shock, keep electrical
connections o ground.
Bung
mCAUTION! Start and stop the tool only while it is held
rmly against the waxing surface. Failure to do so may throw
the bonnet from the polishing pad.
Fig. 1
Terrycloth
bung bonnet
Buer +
polisher
Fig. 2
Terrycloth
bung bonnet
Wax