Replacement Part List

11
4. When the charger lights turn green, the batteries are fully
charged (Fig. 3).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in
1 hr 50 min (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery packs are fully seated into the bay. Remove
the battery packs and reinsert. If the problem persists,
contact an authorized Snow Joe
®
+ Sun Joe
®
dealer or
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the batteries from the
charger by pressing the push lock buttons and sliding the
batteries backward to unlock them from the charger
(Fig. 4).
mCAUTION! FIRE HAZARD. When removing the batteries
from the charger, be sure to unplug the charger from the outlet
rst, then remove the batteries from the charger.
mWARNING! This charger does not automatically turn
o when the batteries are fully charged. Please take care not
to leave the batteries in the charger. Switch o or unplug the
charger at the mains when charging is complete.
7. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to the
batteries.
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery packs' temperatures are outside the charging
range. Once the packs are within the acceptable range,
normal charging will take place and the red light will be
continuous. Hot or cold battery packs may take longer to
charge.
Assembly
m
WARNING! Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and severe personal injury.
Always wear gloves during assembly.
Connecting the Handle
1. Fit the upper handle frame on the lower handle bars, and
secure with 2 sets of handle knob and bolt (Fig. 5).
2. Clip the cable clips on the handle, and Insert the cable in
the cable clips.
Fig. 4
Push lock
button
Lithium-Ion Charging Status
Battery
Pack
Temperature
Charger
Base
Indicator
Light
Battery
Pack
Indicator
Light
Charging
Status
Too hot
Green
Flashing
together
Not charging
Normal range
Red
Flashing
one by one
Normal
charging
Too cold
Green
Flashing
together
Not charging
R
Fig. 5
Upper handle
frame
Lower handle
bars
Handle knob
Bolt