Replacement Part List

13
Sweeping
Fanning action can be used for quick and easy clean up.
Keep the SharperBlade
™
parallel to and above the surfaces
being swept and move the tool from side to side (Fig. 15).
Edging
mWARNING! Because this procedure is close to the
On/O switch, make sure to remove the battery before
converting the machine.
1. To convert your SharperBlade
™
trimmer into an edger,
slide the Twist-N-Groom
™
locking collar downward and
twist the handle clockwise to an angle of 180° while
holding the pole. Release the collar and ensure it snaps
into place (Fig. 16).
2. Loosen the handle knob and adjust the auxiliary handle by
pivoting it to a comfortable position. Tighten the handle
knob to secure (Fig. 17).
3. Use the edge of the guard as a guide when cutting near
fences and walls (Fig. 18).
mWARNING! Do not trim near electrical wires.
4. To convert your edger back to a trimmer, hold the handle,
slide the Twist-N-Groom
™
locking collar downward and
twist the handle counterclockwise to an angle of 180°
while holding the pole. Release the collar and ensure
it snaps into place (Fig. 19). Adjust the auxiliary handle
as needed.
Fig. 15
Fig. 16
Twist-N-Groom
™
locking collar
Slide downward
Twist 180°
clockwise
2
Fig. 17
Handle knob
Auxiliary handle
Fig. 18