Replacement Part List

13
Note: Refer to Set the Swivel Angle section on page 10 for
detailed instruction of how to adjust the swivel angle.
7. The other side of the chain teeth should be able to t the
same setting of chain stop and grinding depth. However,
it's recommended to double check everything before
inserting the battery and turning on the machine.
8. After all of the teeth have been sharpened, turn o the
machine and remove the battery.
Operating Tips
mWARNING! To ensure that the chain saw works safely
and eciently, it is essential that the cutting components
are well-sharpened. Any work on the chain and bar requires
specic experience and special tools.
Sharpening is necessary when:
• the sawdust looks like dust;
• cutting becomes more dicult;
• the cut is not straight;
• vibrations increase.
After sharpening, check that the depth limiter tooth does not
stick out farther than the inspection tool and le any projecting
parts with a at le (not included), rounding o the edges
(Fig. 18).
Maintenance
Please contact an authorized Snow Joe
®
+ Sun Joe
®
dealer
or call the Snow Joe
®
+ Sun Joe
®
customer service center
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualied
personnel will completely invalidate the warranty.
Maintain the product with the following recommended
procedures. It is recommended to check the general condition
of every part before using. Keep your tool in good condition.
Keep all cutting edges sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control. Keep handles dry, clean, and free
from oil and grease.
Cleaning
We recommend that you clean the device everytime
immediately after using. Clean with a moist cloth and a soft
soap or blow it with compressed air at low pressure.
• Remove the battery each time before cleaning.
• Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible.
• Do not use cleaning agents or solvents; these could attack
the plastic parts of the equipment. Ensure that no water
can seep into the device.
Fig. 17
Top view of the
tooth
Swivel angle for
the other side
Swivel angle
for one side
20°
Fig. 18
Inspection tool
Depth limiter tooth
Cutting edge
Depth
limiter
tooth