Instruction Manual

6 of 7
Programming Instructions
STEP 3: ADVANCED PROGRAMMING (CONTINUED)
COPYING, DELETING OR GROUPING WITH A REMOTE
The remote scenario chart below outlines different ways to copy, delete or group channels using separate remotes.
1
Channel
1
Channel
1-15
Grouped
Channels
or
1,2,3...15
Separate
1-15
Grouped
Channels
or
1,2,3...15
Separate
Separate channels can also be programmed this way within one 15 channel remote.
Follow the steps below to copy, delete or group channels.
COPYING/GROUPING CHANNELS
Setup is
complete
Using
original
remote
or
channel
Motor
beeps
1X
Motor jogs 1X
PRESS
P2
Using
original
remote
or
channel
Motor
beeps
1X
Motor jogs 1X
PRESS
P2
Using new
remote or
channel
(to be copied
or grouped)
Motor jogs 2X
PRESS
P2
Motor
beeps
3X
DELETING CHANNELS
Note: this only works on previously copied/grouped channels.
Setup is
complete
Using
original
remote
or
channel
Motor
beeps
1X
Motor jogs 1X
PRESS
P2
Using
original
remote
or
channel
Motor
beeps
1X
Motor jogs 1X
PRESS
P2
Using new
remote or
channel
(to be deleted)
Motor jogs 1X
PRESS
P2
Motor
beeps
3X
COPIE OU SUPPRESSION D’UN MOTEUR PRÉCÉDEMMENT PROGRAMMÉ
DELETING OR TRANSFERRING GROUPS OF MOTORS ARE RECOMMENDED TO BE DONE USING THE
ORIGINAL REMOTE THAT WAS SET UP.
Motor
beeps
1X
Setup is
complete
Motor
beeps
3X
HOLD
until motor jogs 1X then
RELEASE to activate this motor
HOLD
until motor jogs 2X
PERFORM FACTORY RESET ON MOTOR
Only perform a motor reset if necessary.
Setup is
complete
Motor
beeps
4X
HOLD until motor jogs 4X
then RELEASE