Instruction Manual
Programming Instructions
1 of 7
Programming Instructions 2022-10-27
MOTOR INFORMATION
1. Ensure motor is protected. Any damages during transportation, storage, installation or misuse can cause the motor to
not work properly.
2. Charge the motor every 6 months to ensure optimal performance.
3. If the battery charge is at a lower level, the motor will beep 10 times to prompt that it needs to be charged.
4. Maximum running time of the motor is 6 minutes without limits. Motor will be asleep after six minutes has passed.
Motor will still be in wake up/programming mode once the motor has restarted.
Programming resides with the motor. Each motor can store
up to 20 copied channels.
CONTROL RANGE
SIGNAL STRENGTH
AND RANGE MAY VARY
DEPENDING ON THE
ACTUAL ENVIRONMENT.
Obstructions
L2
L1
Roller Shade
Remote
55°C
-10°C
Working
Temperature
L1 Open Area L2 With Obstructions Emission Frequency
200m 35m 433.92/868 MHz
RECHARGING THE MOTOR
To recharge the motor’s battery, connect the SG DC charger to the motor head charging jack and plug the charger into
a standard electrical outlet. When the battery is fully charged, the indication light on the charger will switch from red to
green. You can also use the SG Solar Panel to keep the battery constantly charged while exposed to sufficient sunlight.
IF PURCHASING MORE THAN ONE CHARGER, PLEASE ENSURE THE OUTPUT VOLTAGE ON THE
CHARGER AND MOTOR MATCH.
Charger Light