Instructions / Assembly

• Checkandtightenifnecessaryallmotormountingclamps.
• Whenloading,distributetheweightoffueltank,battery,tackleboxesetc.evenlyacrosstheboatsothatitwillsitreasonablylevelinthe
water. Remember this is a small boat and extra caution should be taken to prevent overloading the craft as this could result in unsafe
operating characteristics.
OPERATING THE BOAT
Launching Tips
• Whenlaunchingtheboatfromshoreitisbettertoenlistthehelpofabystanderorpassengertohelplifttheboatandcarryittothe
water. You can drag the boat but carrying it will prevent excessive hull abrasion over time.
• Besuremotoristilteduptopreventdamagewhenloweringtheboatintothewater.
• Iflaunchingfromatrailer,makesuretoremovealltiedownsbeforebackingontothelaunchingramp.
• Makesuretoinstallalldrainplugsbeforeputtingtheboatinthewater.
• Whenenteringtheboat,stepinthecenteroftheboatsotheboatremainsstable.Donotsteponthegunwale(topedgeofthesideof
the boat), which could cause the boat to tip.
• Aftertheboatisinthewater,butbeforeleavingfromshore,checktomakesuretheboatsitsreasonablylevelforetoaftandsidetoside.
If not, redistribute the items you have on board.
• Beespeciallyconsciousoftheshorecondition.Sharprocks,sharpedgesonbreakwalls,concreteaprons,etc.canseriouslychafethe
hull if you drag or slide the boat over these surfaces.
Mooring and Docking
• Avoidmooringordockinginveryshallowwaterwherethehullwillhitbottom.
• Useboatfendersorothercushioningtopreventwaveactionfromscrapingthehullagainstthedock.
Livewell Operation
• Fillthelivewellabout2/3fullofwater.Do not overfill. The excess water will seep between the hull and deck. Try to use cool water.
Cooler water reduces the fish’s need for oxygen. Keep the lid closed when possible to help keep the water cool.
• ThePro102andPro120modelshavearecirculatingaeratorpump.It’snotnecessarytorunthepumpcontinuouslytokeepfishalive.
Running it for five minutes or so every ½ hour is adequate if the water is cool, longer if the water is warm. Sometimes the pump intake
vanes and spray head parts can become clogged with debris. Periodically check them and clean when necessary. The pump draws
approximately 1 ½ amp @ 12 VDC. The switch is on the electrical control panel.
• Drainthelivewellbyremovingthedrainplug.