Instructions / Assembly

INSTALLING ACCESSORIES
Fish Finders/Depth Finders Pro 94 and Pro 102 Models
1. Hook up power for the fish finder or other accessories. The power will need to be connected directly to the battery. Since this is not a
fused connection, please see the installation instructions included with the fish finder.
2. Place the main unit of the fish finder or other accessory on the deck in any location that is convenient.
3. The transducer for the fish finder can be mounted to the trolling motor using stainless steel hose clamps. The transducer can also be
mounted on a raised mounting block located on the port (left) side of the transom for the Pro 102 and Pro 94. This raised mounting
block has a small piece of durawood behind it as a backer. Do not mount the transducer anywhere else on the transom. There are no
other wood backers (except for the center section where the motor is mounted). Mounting onto the plastic itself will not provide
adequate support, and will create a leak in the hull.
Fish Finders/Depth Finders Pro 120
The transducer for the fish finder may be mounted on either side of the stern. See photo #6. Use caulking to seal
the mounting screws and locate the transducer away from the turbulence. The transom consists of 1” plywood. The
transducer can be placed on either side per the diagram. Do not mount into the outside sponson because there is only
the material thickness of the hull to screw to and a leak will result.
See the instructions from the fish finder manufacturer for more details.
PRE-LAUNCH CHECK
• Checktheweatherandwaveconditions.
• Reviewthemaximumcapacitiesonthecapacityplate,locatedontherearstarboardsideofthedeck.Ensureyouaresafelywithinthese
limits.
• Makesureyourdrainplugsareinstalledandsecure.
• Somewateraccumulationshouldbeexpectedbetweenthedeckandhull.Itisnotnecessarilyanindicationofaseriousleakinthehull.
Water can seep through and around some fasteners during heavy rain or will accumulate just from normal condensation. Drain the space
between the deck and hull of any accumulated water by following the boat specific “Installing Drain Plugs” instructions. Reinstall the
drain plug.
• MakesureallpassengersarewearingPersonalFlotationDevices(lifejackets).
• Whentheboatisunderpower,itisadvisedthattheoperatorandanypassengersremovetheseatpedestal(Pro120only)andplacethe
seat directly into the seat base. Do not sit elevated in the pedestal seats while the boat is in motion.
Photo #6 Mounting
Locations
Pro 120 shown