Instructions / Assembly

Manufacturer’s Statement of Origin (MSO)

Each boat comes with a document called a Manufacturer’s Statement of Origin (MSO). Think of it like the title to your car. It’s your proof,

along with your sales receipt, of ownership. You’ll need both the MSO completed and signed by the retailer and your sales receipt to

Most states require that you register your boat if it has a motor or will be used with a motor. Also, several states require you to register the

boat if it exceeds a certain length. To determine the registration requirements please check with your state licensing bureau. This varies from

state to state but is often the Secretary of State, Department of Natural Resources or the Department of Motor Vehicles.

Owner’s Manual

Keep your owner’s manual for future reference. It is a good idea to write down the following information:

Serial Number ___________________________________________

Date of Purchase ___________________________________________

Purchased from ___________________________________________

SETTING UP YOUR FISHING BOAT

Components and Basic Set-Up

Please follow the recommended steps to prepare your boat. Note: the manual will refer to different models. The large decal on the side of

the boat shows the model.

Parts

• ThePro120comeswith:(2)paddedseats,(2)kingpinswivels,(2)pedestals,(3)transomdrainplugsinstalled,(1)drainpluginstalledin

front/center cooler, (1) stern light (located under the rear casting deck) and (1) trolling motor plug.

• ThePro102comeswith:(2)paddedseats,(2)kingpinswivels,(3)drainplugsinstalled,(1)sternlight,(1)bowlight,(1)batterybox,(1)

accessory kit and (1) trolling motor plug.

• ThePro94comeswith:(2)seats,(2)kingpinswivels,(3)drainplugsinstalled,(1)batterystrapand(1)trollingmotorplug.

Applying Decals

Before applying boat registration decals, clean the area with alcohol or any solvent that does not leave a residue. Make sure solvent is put

aside and is dry. Using a propane torch, lightly pass the flame back and forth over the area where the decals will be applied. Do not try to

heat the surface. This process will enhance the adhesion of the decals.