User's Manual

12
to turn off cell phones and other external power supply。
¾ T-FLASH card inserts: alignment card slot for memory cards
inserted until it fixed so far。
¾ T-FLASH card pull out: when you need to remove the storage
card, please shut down, moved to a different external
power supply, take cards。
2.2 Battery
Initial state of the power battery to about 50%, open can
be used after. New battery charging at least 12 hours, until the
first completely run out (power drain problem) then after fully
charged with; the second time to completely run out and charged
again, after three consecutive cycles, batteries are easier to
achieve the best use。
2.2.1 Battery removal and installation
¾ When demolition by following these steps：
¾ 1. Pushing down the cell phone battery cover, remove the
back cover。
¾ 2. Lift the battery from the battery of distal up removed。
¾ Installation by following these steps：
¾ 1. Into the cell above the first card (note that the
battery of shrapnel)。
¾ 2. The battery down flat on the top, the installation is
complete。
2.2.2 Battery charge
¾ Insert the charger plug in power supply。
¾ Plug the charger connector into the phone's side。
¾ At this point, right corner of the screen's power
indicator will cycle through the flashing; if the charge
has been shut down, screen charge indicates also appears
on the screen, the batteries charging. If your mobile
phone when the low battery is still excessive use, and may
take some time after charging has started charging
instructions that appear on the screen until the symbol。
¾ When the power indicator on the top right corner of the