Felix Storch, Inc. SUMMIT PROFESSIONAL DIV.
Page 2 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. APPLIANCE SAFETY Your safety and the safety of others are very important to us. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. You can be killed or seriously injured if you do not follow these instructions.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Page 3 INSTALLATION INSTRUCTIONS UNPACKING Excessive Weight Hazard! * Use two or more people to move and install your appliance. Failure to do so can result in back or other injury. ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO DRAIN. 1. Remove Packaging Materials 2. Remove tape and glue residue from surfaces before turning on the appliance.
Page 4 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. INSTALLATION INSTRUCTIONS CHOOSING THE RIGHT PLACE Place the appliance in a dry and regularly ventilated place. It is recommended that this appliance always be operated in an ambient temperature of at least 60°F and under 85°F. The appliance may be exposed to lower or higher temperatures but only for a short period of time and the temperature should never be lower than 45°F. Never place the appliance near heat emitting devices (e.g.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Page 5 APPLIANCE USE In order to ensure proper temperature, you need to permit proper airflow in the appliance. Do not block any air vents. If the vents are blocked, airflow will be prevented, and temperature and moisture problems may occur. Always position contents to allow some airflow between shelves or baskets. Allow the appliance to cool at least 6 to 8 hours before adding contents. Allow 24 hours for temperature to stabilize.
Page 6 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. APPLIANCE OPERATION Base Grill (some models only) To Remove and Replace the Base Grill: 1. Open the appliance door and remove the base grill by pulling down and out from the top. 2. Replace the base grill by putting the clips in the openings in the appliance panel. Push in until the base grill snaps into place.
Page 7 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. APPLIANCE CARE Cleaning Your Frost-Free Refrigerator Use nonflammable cleaners. Frost-free means that you do not have to defrost your appliance. Frost is removed by air moving and collecting any moisture and depositing it on the cooling coil. The cooling coil periodically warms up enough to melt the frost, and the water then flows down to the drain pan (located behind the base grill) where it is evaporated.
Page 8 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. TEMPERATURE SELECTION YOUR APPLIANCE MAY HAVE A MECHANICAL (DIAL) OR DIGITAL THERMOSTAT. INSTRUCTIONS FOR BOTH FOLLOW: MECHANICAL THERMOSTAT INSTRUCTIONS The refrigerator is controlled with a thermostat knob located inside the unit, towards the upper right-hand corner. Turn the knob clockwise from the STOP (0) position toward the higher numbers for colder temperatures.
Page 9 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. KEYPAD LOCK (optional on most models) Factory set default password: The factory set default password is 0123. If the default password is lost, press the key (located inside the battery box) for 30 seconds then wait for the warning sound which signifies the factory set default password has been restored.
Page 10 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. ALARM INSTRUCTIONS (alarms are optional on most models) SETTING THE HIGH/LOW ALARM 1. Press the MODE button until unit is in the ALARM DISPLAY MODE indicated by the display of current temperature and HI and LO alarm settings. 2. To set the HIGH temperature alarm limit press the HI button, to advance the display in 1° increments, until the desired high temperature is displayed. Press and hold the HI button to rapidly advance the display in 5° increments.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Page 11 INSTRUCTIONS FOR INTREGRATED FRAME (SUFFIX ’IF’) FOR BUILT-IN APPLICATIONS Note: The directions below are for installation under a cabinet in a 24 inch cutout space. If you will be using this product in a freestanding application, please skip below, and begin with step A1 in lower half of page. 1) Remove door from chassis by unscrewing 3 screws in top hinge and 2 screws in bottom hinge. Keep screws, discard hinges.
Page 12 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. APPLIANCE OPERATION FF6BI - FF7BI – SCR600LOS – SPR7OS- SPR601OS – SCR600BI - SWC6GBI - ALB751— ALB753B Series DEFROST SYSTEM, OPERATION AND SHELF ADJUSTMENT - All models of the above series are all-refrigerators, with no freezer compartment and an auto-defrost system. During the compressor operation, ice will build along the rear cold wall (the evaporator plate is behind the wall).
Page 13 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. APPLIANCE OPERATION BI605FF Series These refrigerator-freezers are fully automatic defrost refrigerator-freezers. They utilize a digital thermostat with a built-in defrost-timer (mounted in the kick-plate) to intermittently turn off the refrigeration system long enough for the freezer plate to melt accumulated ice.
Page 14 Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. INSTALLING A PANEL INTO A SUMMIT FRAME (“FR” SUFFIX) On any model that includes suffix “FR” in the model number, and on all models BI540, BI541,ALB651, ALB653B, ALB751 and ALB753B) a two piece stainless steel frame is mounted on the door. The models can be used without a panel, but to install a panel follow the directions below. (Panel size is 23 1/8” W x 28 1/8” H) 1. Carefully lay the refrigerator (it must be empty) on its back. 2.
Felix Storch, Inc. SUMMIT PROFESSIONAL DIV. Page 15 TROUBLESHOOTING Try the solutions suggested here first to avoid the cost of an unnecessary service call... Your refrigerator or freezer will not operate: • Has a household fuse blown or circuit breaker tripped, or is the outlet not receiving power or switch controlled? Replace the fuse or reset the circuit breaker. Check the outlet with a small appliance you know works.
WARRANTY Call customer service toll free in the U.S.A. @ 1-800-287-8799; Monday to Friday 9:00 am. - 5:00 p.m. (EST). Order parts online at www.summitapplianceparts.com ONE YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory specified parts and repair labor to correct defects in materials or workmanship.
