Use & Care
16
minutes at each of the lower speeds until it stops and the lighting switches o.
Five-button panel (Fig. P4 on page 11)
1. Extractor fan operating control pilot light.
2. Lighting on and o.
3. Extractor fan o.
4. Extractor fan speed - button: speed 1, 2 and 3
Touch panel (Fig. P5 on page 11)
1. Filter clean warning display/button. Warning of the need to replace the filter
– press to deactivate once the filter has been cleaned or replaced.
2. Enable and disable extractor fan timer.
3. Lighting on and o. Keep pressed down to adjust the lighting intensity.
4. Extractor fan on and o.
5. Extractor fan speed - button: speed 1, 2 and 3/4
Timer: The extractor fan works for 5 minutes at the current speed and another 5
minutes at each of the lower speeds until it stops.
Sliding touch panel (Fig. P6 on page 11)
1. Extractor fan on and o.
2. Sliding touch panel for extractor fan speed control. Also used in combination
with button -3-.
3. Lighting on and o. Press the button and, while it is flashing, adjust the
lighting intensity using the sliding touch panel -2-.
4. Enable and disable extractor fan timer.
5. Clean Filter warning display/button. Warning of the need to replace the filter
– Press to deactivate once the filter has been cleaned or replaced.
Timer: The extractor fan works for 2 minutes at the current speed and another 2
minutes at each of the lower speeds until it stops and the lighting switches o.
Warning on the ZEN Model: The front panel automatically extends and retracts on
switching the hood on/o.
HOOD MAINTENANCE
Warning: Always switch o the electricity supply before carrying out
maintenance work on the hood. In the event of a fault, contact an oicial
distributor or authorized dealer.
Exterior cleaning: Use non-corrosive, liquid detergent and avoid the use of abrasive