Use & Care
14
found acceptable for use with this model range hood.
• The minimum distance to the hood must be at least 65 cm (about 25”).
Hood installation on ceiling (page 9)
• Remove the Styrofoam protective piece before use.
• The accessories needed for installation are inside the hood.
• Use the two screws to attach the reducer pipe H to the upper platen (Fig. 1). Connect
the 6” non-flammable pipe to the opening in the ceiling.
• Confirm that the ceiling will support the weight of the hood. Drill 4 holes in the ceiling
using a 5/6” bit and insert the plugs (Fig. 2).
• Adjust the length of the telescopic structure and attach the two pieces with 8 screws
and washers. Bear in mind that the minimum distance from working surface to the
base of the hood should not be less than 25” (Fig. 3).
• Attach the previously adjusted telescopic structure to the ceiling using 4 screws and
washers (Fig. 4).
• Introduce pipe J with the grate on the upper part and attach the telescopic structure
using 2 screws (Fig. 4).
• Introduce pipe K and keep it raised (Fig. 5).
• Aix the hood to the telescopic structure using the nuts and washers (Fig. 5).
• Lower pipe K and attach it to the hood with 2 screws (Fig. 5)
Connecting the hood to the grid
Warning: Before connecting the hood: Switch o the electricity supply and
check that the supplied voltage and frequency coincide with that indicated on
the appliance nameplate.
Connect the hood directly to the electrical grid, protected by a separator device
accessible for disconnection, in line with local regulations.
USE OF THE HOOD
WARNING: NOT SUITABLE FOR USE WITH SOLID-STATE SPEED CONTROLS.
Safety
Warning: The hood may stop working during an electrostatic discharge (e. g.
lightning). This involves no risk of damage. Switch o the electrical supply to the
hood and reconnect after one minute.
Do not allow the hood to be used by children or persons with reduced (physical, sensory