Owners Manual

8
Interior Light
The unit is equipped with an interior light that can be turned on and off by pressing the key.
Placing Items in the Appliance
The Cold Zone
®
refrigerator employs a system of forced circulation of cold air. If this circulation is
obstructed, items will not be adequately refrigerated. Take note of the following points:
• Do not let items obstruct the cold air inlet and suction outlet.
• Place items so that they do not protrude beyond the shelves. The gap between the shelves and
the doors is intentional, and is designed to allow free circulation of cold air.
• Arrange items evenly on all shelves.
• Do not display items on the floor of the interior cabinet. Items must be placed on the shelves.
Shelves
Some units may be equipped with adjustable or removable shelves.
Removable Shelves
• There are four removable shelves inside the unit
• To prevent damaging the door gaskets, make sure to have the door(s) all the way open when
pulling the shelves out of the rail compartments.
• Before removing a shelf from the inner rails, make sure to remove all shelf contents first.
Adjustable Shelves
• If your unit has adjustable shelves, first remove all shelf contents.
• Remove the shelves from the unit, making sure to open the doors fully to prevent damaging the
door gaskets.
• Adjust the brackets hanging on the pilasters to your desired height, then replace the shelves
onto the brackets.
Defrosting
Defrosting is performed automatically and drain water is collected in the drain tray at the back of the
unit. Water in the drain tray is normally evaporated automatically. Under humid conditions, a large
amount of water may accumulate in the drain tray, which may have to be emptied manually.
Changing the Light Canopy Logo
The light canopy, which runs along the top of the unit, can be replaced with a customized plastic
sign, if desired. To change the light canopy display, follow these steps:
1. Locate the two screws on the top of either end of the canopy, and remove them using a Phillips
head screwdriver or drill bit.
2. Pull the top of the canopy up and off of the unit.
3. Slide the blank white plastic display up and out. It can now be replaced with your customized
display.
NOTE: Your customized display must be 35.67” W x 2.67” H (906mm W x 68mm H).
4. Once your display is in place, replace the canopy top, being careful the new display sits inside
the notch which runs along of the box top. This will ensure the display is secure and aligned
properly in your unit.
5. Replace the two screws on either end of the canopy, to secure the top in place.