Commercial Countertop Beverage Center Model SCR114L INSTRUCTION MANUAL To ensure safe operation, please read this instruction manual thoroughly before use. FELIX STORCH, INC. Summit Appliance Division ISO 9001:2015 registered 770 Garrison Avenue Bronx, New York 10474 www.summitappliance.com Write Serial No.
TABLE OF CONTENTS Important Safeguards .............................................................................2 – 3 Moving and Installing the Appliance ..............................................................4 Reversing the Door Swing ......................................................................4 – 5 Preparation ....................................................................................................5 Safety Precautions ........................................................
IMPORTANT SAFEGUARDS WARNING To reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic precautions: • Read all instructions before using the Beverage Center. • Plug into a grounded 3-prong outlet. Do not remove grounding prong, do not use an adapter, and do not use an extension cord. • It is recommended that a separate circuit, serving only your Beverage Center, be provided. Use receptacles that cannot be turned off by a switch or pull chain.
• • • • • which is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase the greenhouse effect. Care must be taken during transportation and setting up of the appliance that no parts of the cooling system are damaged. Leaking coolant can ignite and may damage the eyes.
Moving and Installing the Appliance a. When carrying the cooler, keep it vertical. The angle of inclination between the sides of the cooler and the vertical should be less than 40ᵒ, otherwise the compressor will be affected and disrupt normal operation. b. After unpacking the cooler, remove the packing materials and place the cooler on a level and sturdy floor near a power socket. c.
3. Remove the plastic insert on the opposite side of the fridge and door. Now fix the top door bracket to this side using the screws that were previously removed. Replace the plastic hinge cover. 4. Remove the adjustable foot at the bottom of the fridge and set aside. 5. Unscrew the two screws holding the bottom door hinge and carefully move it across to the opposite side. Before fixing it into position, fit the door to the top and bottom hinge (care must be taken as the door will be loose).
Safety Precautions a. b. c. d. e. f. g. h. 3-hole power socket and fuse are required. Do not damage the power cord or plug. Never splash water on the cooler directly. Never store explosives or hazardous materials such as ether, gas, alcohol, bonding agents, gunpowder, etc., in the unit. Do not use flammable materials such as paints, lacquers, etc., near the unit. Risk of fire. If unit is unplugged, wait 5 minutes before plugging back in.
Maintenance Disconnect the power supply before maintenance on the machine! a. Wipe off any dirt on the condenser regularly to maintain good ventilation. b. Keep the door gasket clean. The gasket can be removed for cleaning and can be mounted again as before. Putting a little talcum powder on the magnetic surface of the door gasket will prolong its service life. Cautions a. This appliance is not suitable for storage of blood, pharmaceutical products and biological products. b.
Disposal of Packaging Do not allow children to play with the packaging, and dispose of plastic bags safely. The cardboard may be broken up or cut into smaller pieces and recycled. Any wrapping cover is made of polyethylene. The polyethylene pads and padding contain no fluorochloric hydrocarbons, and as such are most suitable for adequate recycling.
Troubleshooting Guide You can solve many common Beverage Center problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling a service technician.
NOTES 10
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
