FROST-FREE BUILT-IN FREEZER Model SCFF51OSWH INSTRUCTION MANUAL BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Write Serial No. (on lower left corner of inside cabinet) here: ________________________________ Felix Storch, Inc. 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-4 Location of Parts 5 Installation Instructions 5-7 Before Using Your Appliance 5 Installation of Your Appliance 5-6 Electrical Connection 6 Extension Cord 6 Reversing the Door Swing of Your Appliance 7 Installing the Stainless Steel Handle 7 Operating Your Appliance 8 - 10 Control Panel 8-9 Sabbath Mode 9 Temperature Memory Function 9 Defrosting 9 Using the Freezer 9 Temperature Alarm / Door Alarm 10 Door Lock 10
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the word DANGER or WARNING.
• • • • • • • • • • • • • • FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL Use two or more people to move and install appliance. Failure to do so can result in back or other injury. To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed. Choose a well-ventilated area with temperatures above 44°F (7°C) and below 90°F (32°C). The appliance should not be located next to ovens, grills or other sources of high heat.
LOCATION OF PARTS LED Light Door Handle Shelves (3) Bottom Grille Security Lock Adjustable Legs Digital Control Panel INSTALLATION INSTRUCTIONS BEFORE USING YOUR APPLIANCE • Remove the exterior and interior packing. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth.
the top and 2” (51mm) at the rear.Take care that the air vent at the front of the appliance is never covered or blocked in any way. • Note: It is recommended that you do not install the appliance near an oven, radiator or other heating source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Don’t install in a location where the temperature will fall below 44°F (7°C).
REVERSING THE DOOR SWING OF YOUR APPLIANCE This unit has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please follow the reversal instructions shown below. NOTE: All parts removed must be saved to allow the door swing to be reversed. 1. Remove the bottom hinge (2) by unscrewing the four lock screws (1).
OPERATING YOUR APPLIANCE It is recommended that you install the appliance in a place where the ambient temperature is between 44º and 90ºF (7º - 32ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The operating temperature range may not be reached.
and will decrease by one degree each time you press the DOWN key. • The range of the temperature control is from -11°F to 11°F. • To view the set temperature at any time, press the UP or DOWN key. The set temperature will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit will reappear in the display window. Interior Light The unit is equipped with an interior LED light which will be turned ON when the door is open.
TEMPERATURE ALARM / DOOR ALARM • • • • An audible alarm sounds if the storage temperature is not cold enough. The temperature display flashes at the same time.
CARE AND MAINTENANCE CLEANING YOUR APPLIANCE • Turn off the power, unplug the appliance, and remove all items, including shelves. • Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). • Wash the shelves with a mild detergent solution. • Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts. • Wash the outside cabinet with warm water and mild liquid detergent.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM Appliance does not operate. POSSIBLE CAUSE • Appliance is not connected to a power supply. • The appliance is turned off. • Tripped circuit breaker or a blown fuse. • The temperature is not set correctly. • The ambient temperature could require a lower temperature setting.
Display “E0”, “E1”. “E2”, “E3”, “E4”, “E5” or “E7”. The alarm sounds and the temperature display flashes. The icon “--” is lit and flashing in the temperature display. • “E0” indicates a communication error for 3-zone models. • “E1” or “E2” indicates that the air temperature sensor has failed. • “E3” or “E4”indicates that the defrost sensor in the evaporator has failed. • “E5” indicates a defrost heater failure. • “E7” indicates a door switch failure.
NOTES 14
NOTES 15
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
