00LB. ICE MACHINE User Manual MODELS: BIM100, SCIM101, ALIM100 Write Serial No. of unit here: ________________________________ Felix Storch, Inc. Summit Appliance Division An ISO 9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Important Safety Instructions 3 Precautions 3 Grounding Instructions 4 Location of Parts 5 Installation Instructions 6-7 Before Using your Ice Maker 6 Installing the Ice Maker 6 Connecting the Water Line 6-7 Installing the Purification Filter 7 Operation 7-8 Ice Full Sensor 7 Ice Thickness Sensor 7 Changing the Purification Filter 8 Cleaning 8-9 Cleaning the Ice Bin 8 Cleaning the Condenser Filler 8 Cleaning the Condenser 9 Using the WASH Mode 9 Sanitizi
IMPORTANT SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION BEFORE USING. WARNING: RISK OF CHILD ENTRAPMENT Child entrapment and suffocation are not problems of the past. Unused or abandoned icemakers are still dangerous, even if they will just “sit in the garage a few days.” • • Before you throw away your old icemaker, take off the doors. Leave any shelves or drawers in place so that children may not easily climb inside. Never allow children to operate, play with, or crawl inside the ice maker.
GROUNDING INSTRUCTIONS WARNING: Improper use of the grounding plug can result in a risk of electric shock. • • • This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord with a grounding wire and a grounding plug. The plug must be used with an outlet that is properly installed and grounded.
LOCATION OF PARTS (Front) (Rear) (Interior) 5
INSTALLATION INSTRUCTIONS Before Using the Ice Maker • • Remove any exterior or interior packaging. Attach the four leveling feet to the bottom of the appliance. NOTE: Before connecting the ice maker to a power source, let the appliance stand upright for approximately two hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • • • • Clean the interior surface with lukewarm water, using a soft cloth.
• • Connect a 3/8” diameter pipe to the tap water line. The pressure of the tap water line should be maintained at a level between 20psi (1.4bar) and 80psi (5.5bar). The tap water line and drain pipeline should be planned and prepared at the place of installation. The electric power, tap water pipeline, and drain pipeline should satisfy all the provisions under local laws and regulations.
Changing the Purification Filter When the purification filter is no longer active, the ice maker will not produce ice. The filter cycle is typically 6 months, but might be shorter, depending on your environment and quality of your water. Replacement filters can be ordered online at summitappliance.com/filter100. To change the filter: 1. Remove the inactive filter by turning it counterclockwise and pulling it out of the filter hole 2. Discard your old filter. 3.
Cleaning the Condenser 1. 2. 3. 4. Unscrew the two screws at the bottom of the front panel. Pull down on the front panel to separate it from the appliance. Use a vacuum cleaner to remove dust from the condenser. After cleaning, insert the front cover into the upper holes, and push up and into place. 5. Tighten the two screws to secure the front panel to the appliance. Using the WASH Mode 1. Set the power switch to the “OFF” position. 2. Remove any ice in the ice basin. 3. Dilute 30g (1.
When the first sanitizing procedure is complete, remove the packing down from the ice basin by pulling downward. Remove the water inside the packing down, and insert it back into the ice vessel sheet. Conduct the sanitizing procedure two more times. Once the third sanitizing procedure is complete and all of the components have been reinstalled, set the power switch to the “ICE” position. Regular icemaking can now resume.
TECHNICAL SPECIFICATIONS Specification Item Unit BIM100, SCIM101, ALIM100 Maximum Ice Making (Based on 10℃) Kg /day (Lbs./day) 50(110.2) Freezing Capability Depth Size (Installed Height) Width 574(22.5) mm(inch) 520(20.4) Height Power Package Ice is made after 30 minutes. Before 862(33.9) (FOOT included) Single Phase Weight 115V / 60Hz 50(110.2) Kg(lb.) After Freezing capability 52(114.
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
