Use & Care

5
INSTALLATION INSTRUCTIONS
Before Using your Refrigerator or freezer
• Remove the exterior and interior packing.
• Before connecting the refrigerator or freezer to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door, if it is not already attached. (See page 8.)
Installation of your Refrigerator or freezer
• The refrigerator or freezer is designed for built-in or recessed or free standing installation for
indoor use.
CAUTION: This refrigerator or freezer is designed for general purpose storage. If storing sensitive
medicine or laboratory grade material, we recommend adding additional equipment for
temperature stability and monitoring.
• Place your refrigerator or freezer on a floor that is strong enough to support it when it is fully
loaded. To level the unit, adjust the front leveling legs.
• For free standing installation, 5” (127mm) of space between the back and sides of the unit, and 4”
(102mm) at the top, are suggested, which allows the proper air circulation to cool the compressor
and condenser. Even for built-in installation, it is a must to keep ¼” (6.35mm) space on each side
and at the top and 2” (51mm) at the rear. Take care that the air vent at the front of the refrigerator
or freezer is never covered or blocked in any way.
NOTE: It is recommended that you do not install the refrigerator or freezer near an oven, radiator or
other heating source. Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Don’t install in a location where the temperature will fall
below 44°F (7°C). For best performance, do not install the refrigerator or freezer behind a
cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the refrigerator or freezer into an exclusive, properly grounded wall outlet.