22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.
2867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 1 Introduction This document describes both the system operation of the TT2301 – a DWA (Device Wire Adapter) and the driver installation and use of the MAGOO control software. 2 System Description The TT2301 is a WUSB Hub which has four Type-A USB plugs and one Mini-B USB plug. The TT2301 requires external AC/DC power supply.
22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 3 Driver Installation 1. Copy the MAGOO folder to your computer’s desktop 2. Power the TT2301 using the AC/DC power cube. Wait about 10 seconds for the TT2301 to boot. 3. Plug the TT2301 directly in a USB port of a laptop/PC using a Type-A to Type MiniB USB Cable. 3. You will be prompted to install the driver for the newly found device.
22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 4 MAGOO Control Software 1. Go to the folder on your desktop and double click the MAGOO.exe application. This will launch the MAGOO control software. You should see a menu similar to the one shown below. 2. From this menu you should see one device in the “Connected Devices” box in the upper right hand corner when the TT2301 is plugged in the USB.
22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 5. To start transmitting, click the “Cont TX” button. You should see most of the menu grayed out as you cannot change parameters during Tx. Below is a screen shot when it is transmitting.
22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 6. To stop transmitting, click the “Cont TX” button and the grayed out portions will become active and may be changed. Below is a screen shot when it is not transmitting. 5 Powering and Operation of the TT2301 Power Up Sequence 1. Start the MAGOO software on the PC/laptop. 2. Apply power to the TT2301. 3. Waited 10 seconds for the TT2301 to boot 4.
22867 NW Bennett Road, Suite 200 Hillsboro, OR 97124 USA Phone: 503 615-7716 • Fax: 503 615-4232 http://www.FOCUSinfo.com 6. On the MAGOO screen you should see the Hub enumerate. You are now ready to begin transmitting. Power Down Sequence 1. From the MAGOO software on the PC/laptop stop transmitting as explained in Section 4. 2. Exit the MAGOO software 3. Unplug power to the TT2301. 4. Remove the USB cable from the TT2301.
