User's Manual

SUMMIT FS848 SLAVE MODULE
Model No. 44-2196 8 of 13 22867 NW Bennett St., Suite 200
[e-mail]
Hillsboro, OR 97124
www.focussemi.com TEL [phone]
FAX: [phone]
© 2009 FOCUS Enhancements
1 Brighton ( Slave Module)
2 Integrated Antenna
3 RF Can
4 Multi pin flex cable
5 Hermiston (Interface Board)
6 Power Input 3.3V
7 Reset button
8 RS232 interface
9 Serial cable
3.1 Boot:
.
¾ Download Focus Enhancement’s terminal software onto your
computer.
¾ Connect a multi pin flex cable from Hermiston (interface board) to
Brighton (Slave Module) as shown in the picture.
¾ Connect a 3.3V DC supply to Hermiston (interface board) from a
variable or a fixed source.
¾ Connect the RS232 interface from J9 of the interface board
(Hermiston) to the serial cable.
¾ Connect the serial cable to the computer’s COM port.
¾ Select the right COM port in the terminal window and verify other
selections with the screen shot below.
¾ Press the reset button for the DUT to boot. Your screen should
look as below.