User's Manual

SUMMIT FS848 SLAVE MODULE
Model No. 44-2196 12 of 13 22867 NW Bennett St., Suite 200
[e-mail]
Hillsboro, OR 97124
www.focussemi.com TEL [phone]
FAX: [phone]
© 2009 FOCUS Enhancements
3.4.2 Select the appropriate TPC register
TPC registers can be set from 0 – 7. In the above command TPC 0 has
been used to set the hex value. The following command selects the
particular TPC setting.
radio rftx 0
3.4.3 Start to transmit
The following command is used to start transmitting
tx -1 (transmit continuously)
If a fixed number of packets need to be transmitted then use
tx 1000 (1000 is the number of packets)