User's Manual

Summit User’s Guide – SDC-SSD40L

SDC-SSD40L_UsersGuide

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

4. Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

IMPORTANT NOTE: FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm between

the radiator & your body.

Industry Canada

Note: You must place “Contains IC ID: 6616A-SDCSSD40L” on the host product in such a location that it

can be seen by an operator at the time of purchase.

User’s Guide Requirements (for Model # SDC-SSD40L)

RF Radiation Hazard Warning

To ensure compliance with FCC and Industry Canada RF exposure requirements, this device must be

installed in a location where the antennas of the device will have a minimum distance of at least 20 cm

from all persons. Using higher gain antennas and types of antennas not certified for use with this product

is not allowed. The device shall not be co-located with another transmitter.

Installez l'appareil en veillant à conserver une distance d'au moins 20 cm entre les éléments rayonnants

et les personnes. Cet avertissement de sécurité est conforme aux limites d'exposition définies par la

norme CNR-102 at relative aux fréquences radio.

Maximum Antenna Gain – If the integrator configures the device such that the antenna is

detectable from the host product.

This radio transmitter (IC ID: 6616A-SDCSSD40L) has been approved by Industry Canada to operate

with the antenna types listed below with the maximum permissible gain and required antenna impedance

for each antenna type indicated. Antenna types not included in this list, having a gain greater than the

maximum gain indicated for that type, are strictly prohibited for use with this device.