User's Manual

User’s Guide – SDC-MSD40NBT

SDC-MSD40NBT_UsersGuide

European Union

User’s Guide Requirements

The integrator must include specific information in the user’s guide for the device into which the SDC-

MSD40NBT is integrated. In addition to the required FCC and IC statements outlined above, the following

R&TTE statements must be added in their entirety and without modification into a prominent place in the

user’s guide for the device into which the SDC-MSD40NBT is integrated:

This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The

following test methods have been applied in order to prove presumption of conformity with the

essential requirements of the R&TTE Directive 1999/5/EC:

 EN60950-1:2001 A11:2004

Safety of Information Technology Equipment

 EN 300 328 V1.7.1: (2006-10)

Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband Transmission

systems; Data transmission equipment operating in the 2,4 GHz ISM band and using spread

spectrum modulation techniques; Harmonized EN covering essential requirements under article

3.2 of the R&TTE Directive

 EN 300 328 v1.7.1 (BT 2.1)

 EN 301 489-1 V1.6.1: (2005-09)

Electromagnetic compatibility and Radio Spectrum Matters (ERM); Electromagnetic Compatibility

(EMC) standard for radio equipment and services; Part 1: Common technical requirements

 EN 301 489-17 V1.2.1 (2002-08)

Electromagnetic compatibility and Radio spectrum Matters (ERM); Electromagnetic Compatibility

(EMC) standard for radio equipment and services; Part 17: Specific conditions for 2.4 GHz

wideband transmission systems and 5 GHz high performance RLAN equipment

 EN 301 893

Electromagnetic compatibility and Radio spectrum Matters (ERM); Broadband Radio Access

Networks (BRAN); Specific conditions for 5 GHz high performance RLAN equipment

 EU 2002/95/EC (RoHS)

Declaration of Compliance – EU Directive 2003/95/EC; Reduction of Hazardous Substances

(RoHS)

This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU

member states and EFTA countries, except in France and Italy where restrictive use applies.

In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain

authorization to use the device for setting up outdoor radio links and/or for supplying public access to

telecommunications and/or network services.

This device may not be used for setting up outdoor radio links in France and in some areas the RF

output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For

detailed information the end-user should contact the national spectrum authority in France.