Installation Manual for SDC-CF10G 802.
Thank you for purchasing a Summit SDC-CF10G 802.11g Compact Flash Module. Before you install the module, you will require the following items and information: • A mobile data terminal, vehicle-mounted device, or other mobile computing device with: - A compact flash (CF) Type I or Type II slot - An internal antenna fitted with Hirose U.FL connectors - Microsoft Windows CE Version 4.2 or 5.0, Microsoft Windows Pocket PC 2003, or Windows Mobile Version 5.
4. Connect to your wireless network Two methods exist for configuring the SDC-CF10G for operation on a wireless network. The first method is called Wireless Zero Config which is the Microsoft program for configuring a generic WLAN card. The other, and preferred, method is to use the Summit Client Utility (SCU).
Summit declares that SDC-CF10G (FCC ID: TWG-SDCCF10G) is limited in CH1~CH11 for 2.4 GHz by specified firmware controlled in U.S.A. This device is intended for host device manufacturers and integrators only under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
- Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
