THREE-ZONE WINE COOLER Models SWC1987T Owner’s Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write Serial Number here: _________________________ Felix Storch, Inc. Summit Appliance Division An ISO9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
IMPORTANT SAFETY INSTRUCTIONS WARNINGTo reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic precautions Read all instructions before using the wine cooler. Plug into a grounded 3-prong outlet. Do not remove grounding prong, do not use an adapter, and do not use an extension cord. It is recommended that a separate circuit, serving only your wine cooler, be provided. Usereceptacles thatcannot be turned off by a switch or pull chain.
Although the unit has been tested at the factory, due to transit and storage, you should clean the appliance before use. Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damageor discolor the interior. Do not use this apparatus for other than residential purposes. This appliance is CFC- and HFC-free and contains a small quantity of Isobutane (R600a)which isenvironmentally friendly, but flammable.
TABLE OF CONTENTS Important Safety Instructions .................................................................... 1 – 2 Location of Parts ............................................................................................... 4 Installation Instructions ................................................................................ 5 - 7 Before using your wine cooler .................................................................. 5 Installation of your wine cooler ............................
LOCATION OF PARTS Upper hinge Uppermost zone Upper control panel Glass door Full-size wooden shelves Middle zone Baffle plate and lower control panel Handle Baffle plate Lowermost zone Short wooden shelf Key lock Ventilationgrille (kickplate) Door seal (gasket) Adjustable legs NOTE: Each zone has a Ventilation fan and a Sensor located on the rear wall.
INSTALLATION INSTRUCTIONS Before Using Your Wine Cooler Remove the exterior and interior packing. Before connecting the wine cooler to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth. This cooler is specifically designed for the storage of wine – do not use it for other purposes.
6
NOTE: All parts removed must be saved to allow the door swing to be reversed. 1. Carefully use a sharp tool to pry up the decorative cap at the top of the cabinet and also the cap of the door hinge (Fig.1). 2. Open the door slightly, remove the screw holding the door hinge cover, remove the upper door hinge cover, then unscrew all the screws holding the upper door hinge. Be sure to hold the glass door firmly while removing the screws and taking off the door (Fig. 2). 3.
OPERATING YOUR WINE COOLER The wine cooler should be placed where the ambient temperature is between 61 and 95 degrees Fahrenheit (16-35°C).If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate.
● LOWER CHAMBER: This displays the actual temperature of the lower chamber. It can display temperatures from 0°C to 37°C (32°F to 99°F). ● °C/°F light: When the °C light is on, the temperature displayed is in Celsius. When the °F light is on, the temperature is in Fahrenheit. Operation of the Buttons ● SET Button of the middle chamber: This button sets the temperature in the middle zone. Each time you press the button, the set temperature increases 1°C or 1°F.
bottom of the door and turn it counter-clockwise to lock the door, making sure the metal pin is engaged completely. To unlock the door, do the reverse. Remove the key and put it in a secure location. Defrosting The wine cooler defrosts automatically during its operating cycle. The water resulting from the defrosting is collected in a drip tray near the compressor at the back where it is automatically evaporated.
Storage of Wine Bottles Your wine cooler was designed to store wine bottles in total security. It can hold up to 133 standard wine bottles. We recommend that you observe the following tips to optimize loading: Spread your bottles out as evenly as possible over the shelves, so that weight is not concentrated in one spot. Also make sure your bottles do not touch the back of the cabinet or the step at the bottom of the lower chamber.
CARE AND MAINTENANCE Cleaning Your Wine Cooler 1. Turn off the power, unplug the appliance, and remove all items including shelves and racks. 2. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. 3. Wash the shelves with a mild detergent solution. 4. Wring excess water out of the sponge or cloth when cleaning the area near the controls, or any electrical parts. 5.
PROBLEMS WITH YOUR WINE COOLER You can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling a service technician. TROUBLESHOOTING GUIDE Problem Wine cooler does not operate. Possible Cause Not plugged in. The appliance is turned off. The circuit breaker has tripped or a fuse has blown. Wine cooler is not Check the temperature control setting.External cold enough.
NOTES 14
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
