Installation Guide
Table Of Contents
- READ AND SAVE THESE INSTRUCTIONS
- IMPORTANT SAFETY INFORMATION
- IMPORTANT SAFETY INFORMATION
- READ AND SAVE THESE INSTRUCTIONS
- Controls
- Filter
- Surfaces
- Stainless Steel Surfaces (on some models)
- Painted Surfaces (on some models)
- Do not use steel wool pads or other abrasive cleaners; they will scratch the surface.
- When cleaning the hood surfaces, be certain that you do not touch the light with moist hands or cloth. A warm or hot light may break if touched with a moist surface. Always let the light cool completely before cleaning around it.
- Lights
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Instructions
- Installation Instructions
- DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
7
To reduce risk of fire and to
properly exhaust air, be sure to duct air outside.
Do not vent exhaust air into spaces within walls or
ceilings or into attics, crawl spaces or garages.
CAUTION
FOR YOUR SAFETY
Before beginning the installation,
switch power off at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
WARNING
Disconnect all electrical power
at the main circuit breaker or fuse box before
installing.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Installation work and electrical wiring must be
done by a qualified person(s) in accordance
with all applicable codes and standards,
including fire-rated construction.
B. Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel-burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer’s guidelines and safety standards
such as those published by the National Fire
Protection Association (NFPA), the American
Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the
local code authorities.
C. When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
D. Ducted fans must always be vented to the
outdoors.
TO REDUCE THE RISK OF FIRE,
USE ONLY METAL DUCT WORK.
WARNING
WARNING
If you have questions, call Summit at 1-718-893-3900 or visit our website at: www.summitappliance.com/support
Under the Cabinet (UTC) Hoods
Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
•
IMPORTANT — Save these
instructions for local inspector’s use.
•
IMPORTANT — Observe all governing
codes and ordinances.
•
Note to Installer – Be sure to leave these
instructions with the Customer.
•
Note to Customer – Keep these instructions for
future reference.
•
Skill level – Installation of this vent hood requires
basic mechanical and electrical skills.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is not
covered under the Warranty.
INSTALLATION INSTRUCTIONS