Installation Guide
Table Of Contents
- READ AND SAVE THESE INSTRUCTIONS
- IMPORTANT SAFETY INFORMATION
- IMPORTANT SAFETY INFORMATION
- READ AND SAVE THESE INSTRUCTIONS
- Controls
- Filter
- Surfaces
- Stainless Steel Surfaces (on some models)
- Painted Surfaces (on some models)
- Do not use steel wool pads or other abrasive cleaners; they will scratch the surface.
- When cleaning the hood surfaces, be certain that you do not touch the light with moist hands or cloth. A warm or hot light may break if touched with a moist surface. Always let the light cool completely before cleaning around it.
- Lights
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Instructions
- Installation Instructions
- DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
5
Filter
Be sure the circuit breaker is off, and all surfaces are
cool before cleaning or servicing any part of the vent
hood.
Charcoal Filter
For this model, the air needs to be recirculated through a
disposable charcoal filter that helps remove smoke and
odors.
NOTE: DO NOT rinse or put the charcoal filter in an
automatic dishwasher.
The charcoal filter cannot be cleaned. It must be
replaced. It is recommended that the charcoal filter
be replaced every 6-12 months or if it is noticeably
dirty or discolored.
To inquire about purchasing replacement charcoal filters
or to find the location of a dealer near you, please call us
at (718) 893-3900.
To install:
1. Slip the back edge of the filter into the retaining
slot.
2. Rotate the filter block pin to fix the filters in place.
To remove the filter, complete the above process in reverse.
A charcoal filter is included with this model.
CARE AND CLEANING: Filters