Installation Guide
Table Of Contents
- READ AND SAVE THESE INSTRUCTIONS
- IMPORTANT SAFETY INFORMATION
- IMPORTANT SAFETY INFORMATION
- READ AND SAVE THESE INSTRUCTIONS
- Controls
- Filter
- Surfaces
- Stainless Steel Surfaces (on some models)
- Painted Surfaces (on some models)
- Do not use steel wool pads or other abrasive cleaners; they will scratch the surface.
- When cleaning the hood surfaces, be certain that you do not touch the light with moist hands or cloth. A warm or hot light may break if touched with a moist surface. Always let the light cool completely before cleaning around it.
- Lights
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Preparation
- Installation Instructions
- Installation Instructions
- DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
15
Installation Instructions
9
FEED-IN WIRES
Lift the hood into position and feed the house
wiring through the wiring knockout.
11
SECURE HOOD
Tighten the mounting screws. Be sure the
screw heads are in the narrow neck of the
keyhole slot.
Mounting
screw (4)
Keyhole (4)
INSTALLATION PREPARATION
8
FOR VENTED INSTALLATIONS
On Some Models:
Install with vented mode deflector part.
On Some Models:
Install vented mode deflector part.
10
MOUNT THE UTC
Place the hood onto the partially installed
screws using the keyholes and slide the hood
back into position.
2
1