Installation Guide

14
4
REMOVE ELECTRICAL
KNOCKOUTS
Use a flat blade screwdriver, remove the
appropriate electrical knockout from the back or
the top of the hood.
7
ATTACH DAMPER/DUCT
CONNECTOR
Attach damper/duct connector over knockout
opening with two or four (D) screws. Make sure
damper pivot is nearest to top/back edge of
hood. Remove any packaging tape to allow
damper to move freely.
Tape
Top/back
edge
Damper (vertical discharge
position shown)
Rectangular Ducting
7” round
exhaust
adaptor
Round Ducting
Installation Preparation
1" = 2.5 cm ; 1' = 0.3 m
INSTALLATION PREPARATION
3
1
⁄4” x 10” Rectangular
6
REMOVE DUCT KNOCKOUT(S)
FOR VENTED INSTALLATION
Determine which ducting option to use.
Using a flat blade screwdriver, remove the
appropriate duct knockout(s) from the top or
back of the hood.
7” Round vertical discharge.
Remove semi-circular duct
vertical discharge.
Remove top
knockout and top rectangular
rectangular duct knockout
only.
duct knockout.
3
1
⁄
4
” x 10” Rectangular horizontal
discharge. Remove rear
rectangular
duct knockout only.
NOTE:
If the hood is to be installed in a
recirculation,
non-vented ductless manner, do not
remove any venting knockouts.
NOTE:
For an ENERGY STAR
®
model, unit must
be
vented mode to be considered ENERGY STAR
®
certified.
5
REMOVE JUNCTION BOX
Remove junction box from inside the hood. Set
the junction box and mounting screws aside.
Junction Box
Screws