Instruction Manual
7
To switch the door handle:
1. Remove the gasket from the inside of the door.
2. There are two screws and two washers holding the door handle to the door. Unscrew these and
remove the door handle.
3. On the opposite side of the door, unscrew the screws holding the handle covers in place. Save
these for later use.
4. Replace the washers and screws into the track on the opposite side of the door, and then attach
the door handle.
5. Insert the screws for the handle hole covers, and while holding them in place, reinstall the handle
hole covers. They will thread onto the screws.
Installing the Handle
This appliance includes a handle that is not required to operate the unit. To install the handle, follow
the instructions below:
1. Use a screwdriver to remove the screws on the side of door where the handle is to be installed.
2. Align the handle with the screws removed in step # 1. Tighten the screws using a Phillips head
screwdriver until the handle is both flush and secured tightly against the door side. (DO NOT
over-tighten as this will cause damage to the door surface.)
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between
44º and 90ºF (7º to 32ºC). If the ambient temperature is above or below the recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in
extremely cold or hot conditions may cause interior temperatures to fluctuate. The operating
temperature range may not be reached.
NOTE: If the door of the unit is left open for more than 60 seconds, an alarm will sound. The alarm
will stop once the door is closed.
Control Panel for Digital Thermostats
Refrigerators and freezers include a digital thermostat located in the kick plate of your unit.
Indicator Symbol Table:
Indicator
Symbol
Status
Meaning
Setting
Set
ON
Set parameters
OFF
Temperature measuring and controlling
Cooling
ON
Cooling active
OFF
Cooling inactive
Flash
Cooling delays
Defrost
ON
Defrost active
OFF
Defrost inactive
Dripping
drip
ON
Dripping active
OFF
Dripping inactive
Measurement unit
indicator light
℃
ON
Unit of measurement display
Measurement unit
indicator light
℉
ON
Unit of measurement display