Installation Instructions and Manual

1
BEFORE OPERATING
SHIPMENT ARRIVING DAMAGED:
INTERIOR LIGHT
DEFROSTING
TEMPERATURE ALARM
CLEANING AND MAINTENANCE
IMPORTANT NOTES:
VISIBLE DAMAGE
If your shipment arrives with visible damage to
the box/carton, be sure the damage is noted on
the bill of freight or express receipt and signed
by the person making the delivery. File claim for
damages immediately, regardless of the extent
of damage.
Disconnect all power supplies and baeries
before servicing
CONCEALED DAMAGES
If damages are unnoticed until the kegerator is
unpacked, notify the transportation company or
carrier immediately and file a concealed damage
claim with them. This should be done within (5)
days of the delivery date. Be sure to hold on to
the box/carton for inspection. We cannot assume
responsibility for damage or loss incurred in
transit.
CONSTRUCTION ZONES
Keep all stainless steel products away from
construction zones. Construction debris such as
(but not limited to) stone dust, stucco, and lime
dust could damage or permanently discolor
stainless steel products. Keep all caustic chemicals
including chlorine and pool cleaning products
away from stainless steel at all times.
This unit is equipped with an interior LED light
which will be turned ON when the door is open
and the interior fan is stopped at the same time.
You can press to manually turn on or tun off
the light.
The unit defrosts automatically in normal
operating conditions. The evaporator behind the
rear wall of the unit defrosts automatically. The
condensation collects in the drainage channel
behind the rear wall of the unit and flows through
the drainage hole into the drop tray by the
compressor where it evaporates.
However, frost may accumulate on the evaporator
if the unit is repeatedly opened in a high heat or
high humidity location. If this frost paern does
An audible alarm sounds if the storage
temperature is not cold enough. The temperature
display flashes at the same time.
The cause of the temperature being too high may
be:
• Too much warm ambient air flowed in
when rearranging and removing stored
items.
• Power failure for some time.
• The appliance is faulty.
The audible alarm is automatically silenced and
the temperature display stops flashing when the
temperature is sufficiently cold again.
Periodic cleaning and proper maintenance will
ensure efficiency, top performance and long life.
The maintenance intervals listed are based on
normal conditions. You may want to shorten
the intervals if you have pets or other special
considerations.
Exterior cleaning for your stainless steel model.
• Turn off the power, unplug the appliance,
and remove all items including the dispense
kit.
• Wash the inside surfaces with warm water
and baking soda solution. The solution
should be about 2 tablespoons of baking
soda to a quart of water.
• Wring excess water out of the sponge or
cloth when cleaning area of the controls, or
any electrical parts.
• Wash the outside cabinet with warm water
and mild liquid detergent. Rinse and wipe
dry with a clean so cloth.
• Do not use steel wool or a steel brush on
the stainless steel. These will contaminate
the stainless steel with steel particles and
rusting may occur.
• Dust the front grill and back of the unit
twice yearly, make sure the power is off
before cleaning.
• It is recommended to clean the unit
completely inside and out yearly to
maximize the longevity of the product.
ELECTRICAL PARTS AND COMPONENTS
WARNING!
not clear within 24 hours, your unit will require
manual defrosting.
Press and hold for 6 seconds, the unit will be
defrosted.
To stop defrost, please repeat the same
interaction.